|
|
|
|
|
|
|
SF-95c+ Satellite Finder signal meter, FTA,DTV,DISH
|
|
|
Time left: |
(8/28/2008 3:30:30 PM) |
Seller: |
|
Bids: |
0 |
babeebluee07 |
|
Current Bid: |
USD 0.99 |
|
|
|
|
|
|
|
|
SquareTrade © AP6.0
YOU ARE BIDDING ON
THIS NEW SUMMER
2009 Model Series - SF-95C+
SATELLITE METER
with light and tone for easy installs
**FREE DISH ALIGNMENT SOFTWARE**
--------CLICK HEREhttp://www.visionplus.us/satcalc.html
YOU MIGHT SEE OTHERS THAT ARE SAYING THEY ARE THE 2009 MODEL BUT DON'T BE FOOLED
THEY ARE THE GREEN BOXES AND THESE ARE BLUE AND CURRENTLY THE NEWEST ON THE MARKET
* GET THEM HERE FIRST *
1- Satellite Finder Alignment Meter
Works on all satellites HD, DTV, FTA, Dish Network, Voom, Bell Express vu, C band satellites as well
circular and linear signals
SF-95c+
Satellite Finder Dish Alignment Tool
"accept no cheap imitations"
Now with H/V and 22KHz indicators
SF-95c+ is a satellite finder that helps to make precise dish set-up easily. Its ultimate sensitivity will indicate 0.2 dB level difference in 950 to 2050MHz. SF-95c+ is miniature (3.03" x 2.36" x 1.10") and light weight (95 gm)
SPECIFICATIONS :
MODEL INPUT FREQ IMPEDANCE MIN. INPUT MAX. INPUT POWER SIZE
SF-95c 950-2050 MHz 70 Ohm -40 dB m -10 dB m 13-18 V 77 x 60 x 28 mm
INSTUCTIONS:
SATELLITE FINDER MODEL SF-95, SF-95c, SF-95c+ OPERATION:
1. Unplug the receiver from the wall.
2. Remove the coax from your LNBF.
3. Connect the coax to the SF-95 meter to the connection that says "TO REC".
4. Using a jumper coax connect to the side of the meter that says "TO LNB".
5. Connect the other end of the jumper coax to the LNBF.
6. Plug in and power up your receiver.
7. Adjust the signal level knob on the front of the meter so the reading is below 5 on the scale.
8. Do a rough adjustment for the azimuth and elevation of the dish to get a starting point. If you don't know
the azimuth and elevation settings you can use SatCalc to find your values. SatCalc is free to use and
can be downloaded at http://www.visionplus.us/satcalc.html
Full View
Like to have it on your desktop?
9. With your signal level at or below 5 on the meter, start to adjust the dish very slowly while watching the
meter. If the meter level goes above 5, adjust the knob on the front of the meter to make the meter read
at or below 5. Repeat as needed.
10.Once you have found the satellite and have peaked it to the highest possible level, go to the receiver
and confirm that you are on the right satellite.
11.If you are using a linear LNBF: After confirming the satellite is correct, adjust your LNBF by turning it in
the holder first to the right and then to the left watching the meter and stopping at the highest point in
signal.
12.Power down the receiver by unplugging the power cord.
13.Remove the meter and re-connect the coax from the receiver to the LNBF.
14.You are now ready to power up your receiver.
IMPORTANT NOTES:
• SF-95c: If you are using the SF-95c you will notice a small compass built into the side of the meter for
finding your azimuth.
• SF-95c+: If you are using the SF-95c+ in addition to the compass, you will notice indicator lights for
verifiying that your receiver is set to Horizontal or Vertical polarity and if 22KHz tone is on or off.
• Green H/V light indicates Vertical Polarity.
• Red H/V light indicates Horizontal Polarity.
• Red 22KHz light indicates 22KHz is ON.
• When aligning a C-band dish do not use your meter in front of the dish to avoid full scale readings.
• When connecting to a LNBF with gain higher than 65dB, insert a 5dB attenuator between the meter and
the LNBF. If a attenuator is not available you may use a long coax (60 feet or more) between the meter
and the LNBF.
• If the meter needle is jumping the sensitivity is too high. Adjust the S.A. level on the back of the meter
by punching through the label where marked. Be very careful not to damage the adjustment by turning it
too far or too hard.
SPECIFICATIONS:
• Frequency Range: 950 ~ 2300 MHz
• Input Level: -25dBm ~ -75dBm
• Gain: 11 ~ 15dB
• Sensitivity(S.A.): 7 Microvolt
• Power Supply: +13/+18V DC
• Operating Range: -52 ~ -65dB (LNBF Gain)
Do not bid until you read and 100% agree with our "terms of sale"
SHIPPED WITHIN 24 HOURS (NOT ON WEEKENDS) AND WITH CONFIRMATION NUMBER
SHIPPING ANYWHERE
" PAYPAL " ONLY AND "POSTAL MONEY ORDER" FOR SECURITY FOR THE BUYER AND THE SELLER
THANK YOU FOR STOPPING AND LOOKING AND DONT FORGET TO LOOK AT MY OTHER AUCTIONS
SquareTrade © squaretrade warranty v2.0
On Jun-11-07 at 09:31:02 PDT, seller added the following information:
On Aug-15-08 at 01:28:40 PDT, seller added the following information:
|
|
|
|